Imec presents inverted perovskite solar cell with 24.3% efficiency – pv magazine International

The researchers of the Belgian research institute used a dual-layer treatment for the perovskite absorber, which they said improved the cell efficiency and stability. The device achieved an open-circuit voltage of 1.17 V, a short-circuit density of 24.5 mA/cm2, and a fill factor of 84.6%.

Belgian research institute Imec has developed an inverted perovskite solar cell with reduced nonradiative recombination and improved interfacial contact.

The cell has a pin structure, which means the perovskite cell material is deposited onto the hole transport layer, and then coated with the electron transport layer – the opposite way round to conventional nip device architecture. Inverted perovskite solar cells typically show strong stability, but have lagged behind conventional devices in terms of conversion efficiency and cell performance.

The device also utilizes an “upper” interface between the perovskite and the buckminsterfullerene (C60) electron transport layer and a “lower” interface between the perovskite and the hole transport layer made of nickel (II) oxide (NiOx). Both interfaces were treated with an ammonium salt known as 2-thiopheneethylammonium chloride (TEACl). The results were compared.

The scientists said the dual-layer treatment resulted in enhanced efficiency, with a relative power conversion efficiency (PCE) increase of 9% compared to a reference non-treated device.

“Optimization of these interfaces can consequently minimize losses and improve energy extraction, resulting in increased device efficiency and operational stability,” stated the researchers, noting that this architecture creates a 2D perovskite layer at the interface. Cells with this configuration usually exhibit large exciton binding energies and are generally more stable than conventional 3D devices due to the protection provided by the organic ligands.

Described in full in the paper “Minimizing the Interface-Driven Losses in Inverted Perovskite Solar Cells and Modules,” published in ACS Energy Lettersthe cell achieved a power conversion efficiency of 24.3%, an open-circuit voltage of 1.17 V, a short-circuit density of 24.5 mA/cm2, and a fill factor of 84.6%.

“Besides the increase in efficiency, we also observed a remarkable stability,” stated Tom Aernouts, R&D manager of the Thin-Film Photovoltaics team. “Indeed, after 1,000 hours of continuous operation under one-sun illumination, the devices showed a 97% performance retention, which is among the current best.”

The group also found that the cell retained 88% of its initial performance after 1,850 h, compared to 55% in non-treated cells.

The academics also used the cells to fabricate a mini module of 3.63 cm2 that achieved an efficiency of 22.6% and a fill factor of 82.4%. “However, commercialization of such applications requires industry-compatible processing techniques, which overcome current stability issues, amongst others,” they specified.

This content is protected by copyright and may not be reused. If you want to collaborate with us and would like to reuse some of our content, please contact: editors@pv-magazine.com.

Check Also

These are the wheels that sink and produce 12 kilowatt hours per day

An invention arrives that will become rivers Power plants. They are sunken wheels and produce …

Leave a Reply

Your email address will not be published. Required fields are marked *